SHS Web Conf.
Volume 49, 2018International Cooperation for Education about Standardization 2018 (ICES 2018) Conference Joint International Conference with 5th ACISE (Annual Conference on Industrial and System Engineering) and World Standard Cooperation Academic Day
|Number of page(s)||7|
|Published online||02 October 2018|
Design and analysis of trapezoidal bucket excavator for backhoe
Mechanical Engineering Dept, Diponegoro University, Semarang, Indonesia
* Corresponding author: firstname.lastname@example.org
Excavator is the most multifunction heavy tool because it can handle other heavy tool such as sloping, dumptruck loading, and breaker. Usually, when doing excavation there is always possibility of breaking of pin in tooth adapter. The aim of this paper is designing bucket excavator using SOLIDWORK 2016 software and doing analysis with ANSYS R15.0 software using finite element analysis (FEA) method. This paper emphasize about the development that is done in the tip of excavator bucket teeth based on the calculation and ANSYS simulation with maximum shear stress result which is in the amount of 50,437 Mpa with maximum deformation level is being found at the part of excavator bucket head.
Key words: Excavator Bucket / Trapezoidal Bucket Design / FEA approach
© The Authors, published by EDP Sciences, 2018
This is an open access article distributed under the terms of the Creative Commons Attribution License 4.0 (http://creativecommons.org/licenses/by/4.0), which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.
Current usage metrics show cumulative count of Article Views (full-text article views including HTML views, PDF and ePub downloads, according to the available data) and Abstracts Views on Vision4Press platform.
Data correspond to usage on the plateform after 2015. The current usage metrics is available 48-96 hours after online publication and is updated daily on week days.
Initial download of the metrics may take a while.